Led light with optional front panels

This project was inspired by Fully enclosed X1C Top Glass Riser no LED wire Gap https://makerworld.com/en/models/171760#profileId-188557

This LED light can be used stand alone, or with the BLV - AMS Riser https://makerworld.com/en/models/19535#profileId-19420

One benefit of having this sit under the riser is that you can lift the riser off without having to disconnect the optional riser LED.

Filament

This project was printed using Bambu Labs matte black, and the Bambu Labs USB LED tape light.

The option front panel fills the gap at the front when using the BLV - AMS Riser.

Without front panel	With front panel

Even without the AMS riser I prefer the look of the light with the front panel attached.

Without front panel	With front panel

I have added some holes and slots so the LED cable tape can be firmly anchored with cable ties where the cable attaches to the LED tape. This prevents the LED tape from being torn by the weight of the cable.

The LED frame has enough space for up to two rows of LEDs around 4 sides. Of course you can add less than that if you wish.

Power The LED is powered by the USB port under the lip at the front. For those interested, my setup is consuming 850mA.   Below is a picture of the USB port under the lip at the front on my printer.
Light Output