1/4 inch to hot shoe adapter

A quick hatchet job 1/4 inch to hot shoe adapter with a printed thread (the other one I found required a 1/4 inch nut which I didn't have on hand).

I've used this to adapt a small camera tripod (Fotopro FY-583) to hold a Rode Videomic Pro hot shoe. Assuming it should work with all Rode videomic models.

Should print in PLA with no support in the default orientation with no problems.

The thread for this design was borrowed from wizprods adapter (this part was a bit beyond my lowly Tinkercad skills), the rest was derived from basic measurements.

Disclaimer: Whilst care has been taken to make this part strong, I take no responsibility for the mount breaking or damaging any expensive hot shoe mounted gear you might own. Use entirely at your own risk.