Search models, users, collections, and posts
ESP8266 D1 Mini Case for WLED
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
0.2mm layer, 2 walls, 15% infill
27 min
1 plate
Open in Bambu Studio
Boost
253
681
168
88
2 k
1.4 k
Released
Description
Remix with two changes:
- Cutout in the side for routing WLED wires to the 5V, GND, and D4 pin holes
- Wider USB hole to support USB-C and MicroUSB variations of the board at the same time
Due to the side cutout the lid is also a bit easier to remove than the original.
The 3 WLED wires must be soldered onto the side of the board that has the antenna and metal heatsink, which faces the case lid. They won't be able to route through the cutout otherwise.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (168)