Earbud Winder - Print in Place

If you like my models, don't forget to boost, download, like, rate, share and all that good stuff!

These do NOT fit Apple buds or ones with an in line mic. If you have those you are welcome to publish a scaled up print profile that does fit them. Thanks!

This is a model I designed years ago to keep my cheap earbuds from tangling up in my backpack. This has been rattling around in my front pocket for years and still going strong. Just place the buds and twist away!

It prints in place and you should be able to pick it up from the build plate and brake it loose. It is possible to pry the outer ring off, so be careful. Depending on the filament it might not be smooth to turn, but with a little bit of silicone or teflon spray it will turn very well. Just on both sides of the outer ring, rotate a bit and wipe off the excess:

These fit all the standard small cheapo earbuds that I bought over the years, but bigger models (apple, with mic's, etc.) might be challenging without scaling up the model.

Happy printing! And don't forget to like, download and follow if you like my models :)

Cheers ,

Rossero

Don't forget to check out my latest models (clickable images):

Harry Potter Labyrinth Game ~ TriFlex - Super Flexible Fabric ~ Melting Drip Clock