Search models, users, collections, and posts
Prusa i3 Metal Frame Ramp Fan Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
0
0
0
0
0
0
Released
Description
Holds a 40mm fan underneath the ramp to cool it. The fan is screwed on the holder with 4-40 screws. The holder is snapped on the Prusa frame (6.5 mm). Make sure that the fan blows upward.
On my printer, the fan is connected using "Prusa i3 Metal Frame Terminal Block Holder" (https://www.prusaprinters.org/prints/43073-prusa-i3-metal-frame-terminal-block-holder).
The left version should be used if your RAMPS is installed on the back of the plate, on the left side. The right version should be used if your RAMPS is installed on the back of the plate, on the right side.
In the picture, the RAMPS is on the left side on the back of the plate.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)