XTool S1 Honeycomb Holder Set

UPDATE: It has been pointed out the color change for the lettering was at a different layer on one of the models, so that has been remedied in the new file…….. 

The new file when downloaded should be called “Honeycomb spacer set with notch corrected color swap layer”.

The Xtool S1 is a Godsend for me, except for one issue. You cant keep the honeycomb steady in the pan. This is a set of blocks that holds the honeycomb in the correct position it blongs in. Each block is marked for where it goes, and the upper right block has a notch in it, that slides right over the rivet of the honeycomb frame, to position it and hold it tight.

“PLEASE NOTE: IF YOU HAVE THE EUROPEAN STYLE RISER, WHICH DOES NOT ALLOW THE HONEYCOMB TO SIT IN THE TRAY AT ALL TIMES, THIS PRINT WILL NOT WORK FOR YOU, AS MODERN SCIENCE HAS NOT ALLOWED PHYSICS TO CHANGE AND ALLOW THINGS TO FLOAT IN MID AIR YET”.

Please do not leave a bad review if you have the european style riser, and this model doesnt work with it. 

It causes others that it will work for, to not download it".