Mimikyu Stash Book for Halloween Trick or Trade
Print Profile(3)
Description
Boost Me (for free)
If you like this design please consider leaving a boost and check out my other work! <3
Get ready for Halloween with this Mimikyu themed storage container with print-in-place hinges! Perfect for holding your Trick or Trade Pokémon booster pack cards collected while trick-or-treating, this fun and functional container adds a festive touch to your Pokémon card collection. Available in three versions - magnetic for 3x3mm magnets, magnetic for 3x2mm magnets, and a non-magnetic option (though a magnetic version is strongly recommended to make sure it stays closed)
Poop Warning:
Two books will fit on one plate and reduce waste, you can enable purge into infill at the risk of color showing through the white of the pages.
If you have suggestions feel free to comment :)
Check out my Large Witch's Stash Book here: https://makerworld.com/en/models/633896#profileId-559035
Check out my Pikachu Trick or Trade Stash Book here: https://makerworld.com/en/models/642893#profileId-568890
More Pokemon Stash Books can be found on my profile: https://makerworld.com/en/@Empty_Dustpan
Storage compartment dimensions are approximately: 64mm x 89mm x 11mm and will safely store around 22 Pokemon cards.
The magnetic version requires 12 magnets - either 3x3mm or 3x2mm.
The magnets I use for my small books can be found below (Unfortunately no Maker's Supply for these sizes):
3x2mm - Amazon Link
3x3mm (Recommended) - Amazon Link
Magnetic Version Instructions:
Simply add a small drop of superglue into each magnet hole with a toothpick before inserting each magnet, keeping the polarity of the magnets in mind.
It is very important to leave the initial layer at .15mm to make sure the tail has the effect of looking brown!
Note:
It is very important to use dry filament and to keep an eye on the first few layers to prevent color bleed and make sure you are dialed in for good bed adhesion (bumping up the bed temp to 60 and cleaning the plate works for me).
Disclaimer:
I am not affiliated with, endorsed by, or associated with any companies or entities that own the intellectual properties that inspire my 3D models. These models are fan-made creations intended for non-commercial, personal use only. All trademarks, copyrights, and characters remain the property of their respective owners.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (23)