EPCOT Spaceship Earth for A1 Mini

This is a scaled down remix of the larger Spaceship Earth build for the A1 Mini.

I also further simplified the build by making a center column that you can wrap an LED strip around since at this size the fairy lights will not fit into the holes. The center is just large enough to accommodate a Dig-uno, so it is a very simple build with WLED.

Steps to build:

1. Print model
2. Insert and glue in small magnets
3. Wrap LED strip around center column, start at the hole and string the strip through the hole, then wrap around the column
4. Insert the column into the model through the center hole in the bottom of the model. Attach WLED controller and set WLED controller in the center of the model
5. Finished

In the BOM, I put Bambu's LED strip, which comes with it's own controller, this strip and controller should work just as well as a Dig-uno