Miata POPUP Headlights Keyhanger - Single Hook

This the COOLEST way to hang keys in my opinion:

Parts to Print:

1. Backplate - 1
2. Main_body - 1
3. hook - 1
4. lifter - 1
5. Pin Small - 1
6. Pin - 1
7. light_Right - 1
8. light_Left - 1

Print Settings:

• Backplate: 15% Gyroid Infill, No supports
• Main_Body: 15% Gyroid Infill, Supports Everywhere, Set “Top Contact Z Distance” to 0.3mm. After the part has been printed remove supports gently and carefully.
• hook: 15% Gyroid Infill
• lifter: 15% Gyroid Infill, Supports Everywhere
• Pin Small/Pin, light_Right, light_Left: 15% Gyroid infill, Supports on Build Plate only

Assembley Instructions:

• For this build we would consider left and right as seen in the picture below:

Left and right lights are also shown in the picture.

• Now take the left light and place it such that extrusion marked in yellow is inside the slot, as shown in below two pictures

Make sure the extrusion in blue is facing the direction as shown in picture. Now press the light onto the shaft and make sure it rotates freely.

Do the same with right light.

• Now take the lifter and insert in the direction shown:

Now align the hole in middle of lifter with two holes inside the main body. Then take the Pin (larger one), and insert it in these three holes. You can also use small pliers to help with this step.

Enter the hook in the slot and use Pin_small to secure in place with the lifter.

• Now slide the backplate in the slot and enjoy your keyhanger.

Note: You can paint the popeyes and bumpers using paint markers similiar to shown in the picture below. I have added painting tool.stl to so you can easily paint the circular section of the popeye.

Also I have tested this model repeatedly and I am sure there will be no issues, but if you face any problems lemme know and I will fix them.

You can download double-hook version here:

https://makerworld.com/en/models/630270