Pennsylvania Railroad South Wind Coaster

Pennsylvania Railroad Train “South Wind” Coasters. Logo is from the drumhead on the rear of the train.

These coasters are 89mm square and 3mm thick.

This print profile worked just fine on my X1C but you may find better settings.

I always apply a self-adhesive cork backing to my coasters. I have listed a link to them on Amazon. You will most likely have to trim them slightly. https://a.co/d/0PjaF1i

If you like railroad coasters, take a look at my other railroad coasters and clocks at  https://makerworld.com/en/@railimages

I would appreciate it if you could rate my print profile and model, and maybe even leave a boost. Thanks and enjoy!