Def Leppard Heavy Metal Rock Band Coasters - Free 3D Print Model

Search models, users, collections, and posts

railimages

Art>Signs & Logos

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

3 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

Def Leppard British Heavy Metal Rock Band

These coasters are 89mm square and 3mm thick.

This print profile worked just fine on my X1C but you may find better settings.

I always apply a self-adhesive cork backing to my coasters. I have listed a link to them on Amazon. You will most likely have to trim them slightly. https://a.co/d/0PjaF1i

I would appreciate it if you could rate my print profile and model, and maybe even leave a boost. Thanks and enjoy!

Comment & Rating (6)

@gabriellamer

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed for a fan and it came out perfectly! Printed with: - BambuLab PLA Basic Black - BambuLab PLA Basic Red - BambuLab PLA Basic Gold

The profile uploader has replied

@railimages

They look good!

@Flatr8er

They came out GREAT! Any chance you know of a holder for them?

The designer has replied

@railimages

I have a square coaster holder on my page with all of the clocks and coasters. I'll put the link here, https://makerworld.com/en/models/420506-square-coaster-holder-to-fit-my-coasters#profileId-323206 I don't know of your going to be attaching adhesive cork squares to the back of the coasters or not but if you are here is what I do. I try to make all of my coasters 3mm thick (The ones you printed should be) and then I apply a 1mm cork backing so for the four of them to fit the holder I change only the height of the holder in studio to aprox 20.6mm which will make the coasters pretty much flush with the top of the holder. If you don't put a backing on the coasters then you will have to adjust the height down. I hope this helps, Ken