Search models, users, collections, and posts
80's Toy Store Radio Controlled RC Car
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
52.6 h
8 plates
Open in Bambu Studio
Boost
20
52
0
0
39
1
Released
Bill of Materials
List other parts
- RC radio and receiver x 1:
- 20mm motor, 16mm mounting holes x 1:
- Electronic speed control x 1:
- Mini servo x 1:
- Battery – compartment is small, check size x 1: 60mm x 80mm
- Antenna tube x 1:
- Losi Mini 8ight spur gear 62 tooth Part LOSB1922 x 1:
- 48p or .5mod pinion 13t or smaller appropriate for your motor x 1:
- RC body pin/clip x 1:
- 6x10x3mm bearings for gearbox x 4:
- 3x6x2.5mm bearings for front wheels x 4:
- 1.4mm music wire for tie rods and drive axle pin x 1:
- suspension springs x 3: 5/16" x 1 1/2" zinc compression spring
- 3x25mm screws for rear axle x 2: goes through bearings to strengthen axle
- Assorted other 3mm, 2.5mm, 2mm and 1.5mm screws x 1:
Description
From Thingiverse (https://www.thingiverse.com/thing:1691343). I just put it into Bambu Studio.
Filaments used:
- TPU - tires
- Black ABS - structural body pieces
- ABS support filament
- Red PLA - body
- White PLA - wheels
- PLA support filament
Needed to complete:
Electronics:
- RC radio and receiver
- 20mm motor, 16mm mounting holes
- Electronic speed control
- Mini servo
- Battery – compartment is small, check size (60mm x 80mm)
- Antenna tube
Mechanical:
- Losi Mini 8ight spur gear 62 tooth Part LOSB1922
- 48p or .5mod pinion 13t or smaller appropriate for your motor
- RC body pin/clip
- 4 – 6x10x3mm bearings for gearbox
- 4 – 3x6x2.5mm bearings for front wheels
- 1.4mm music wire for tie rods and drive axle pin
- 3 - suspension springs – OP used Part 88018 from Menards 1 for each front and 1 split in half for rear (5/16" x 1 ½" zinc compression spring
2 – 3x25mm screws for rear axle – goes through bearings to strengthen axle
Assorted other 3mm, 2.5mm, 2mm and 1.5mm screws
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)