Dust Devil Milwaukee Fuel Wind Guard

NOT FOR EXTENDED USE. May cause premature wear on your drill motor. Personally I don't think it would do any harm to your drill especially if you are a small project DIYer like myself, but I had comments on my old model saying it may so I decided to disclose it before anything else. I just wanted something that would keep the wind from the drill from hitting me in the face. While I did add ducting and additional reinforcement material, the ducting really comes from the three fins that hold the guard to the drill. It does not block the wind coming from the drill, it just redirects it forward, which is great if you also want the dust blown from your project. You can also embed magnets into the four corners so the back will hold your other bits if you need to countersink or step up drill hole sizes.

Black Hatchbox PETG

.2 layer height

I printed mine at 10% infill but would recommend at least 15% infill

A pause at layer 33 to embed magnets 

No supports if you want to put in the .25"x.125" magnets (with supports if you don't care to use magnets, just remember to remove it from the ducting on the inside of the two fins so it isn't blocking the wind duct)

This was printed on my QIDI Q1 Pro using QIDIslicer