Search models, users, collections, and posts
Clip on battery bank holder for seestar s50
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, tree supports
2.2 h
1 plate
Open in Bambu Studio
Boost
55
151
16
3
223
116
Released
Description
Holder for any battery bank that is less than 70mm x 25mm. Clips onto seestar s50 tripod below foam. With 3ft cable it hasn't wrapped up with normal use. I printed with elegoo PLA at 15 percent infill and it is sturdy and snaps on strong. I used tree supports and printed upside down and came out clean.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)