MyNameIsJeff

0.2mm layer, 2 walls, 15% infill

Printed great out of white Sunlu PETG using Normal supports. I used 5% gyroid infill to keep it light and reduce print time.

Super comfortable and will definitely help keep my hands from cramping when using the Lite2 for an extended period of time. 

NoobishNemo

Worked perfectly with PLA + support material

Gr3dstampaidee

BeanGoof

cover

plate_1.png

2024-08-05_0b6469029e73c.jpg

2024-08-05_9ff7c53bccd418

<ul><li>Print the controller vertically, with the handles on the build plate with normal supports. &nbsp;I've tried organic tree and that works well too, but the supports are easy to remove here if you use Support for PLA as an interface layer. &nbsp;I've yet to try using PETG as an interface but that could work too.</li><li>If you're looking to minimize some layer lines, I recommend using variable layer height towards the top of grips on the back and where the bottom of the controller sits, though this isn't required and the lines are hard to see even at .2mm because of the vertical print orientation.&nbsp;</li></ul>

<p>Simple controller adapter for the 8BitDo Lite 2 to make it shaped a bit more like a normal controller.  Prints well in PLA using Support for PLA for the interface material, however the supports are in places you&#39;re not going to touch while using the controller if printed vertically so all PLA will work as well.</p>

Print Profile(1)

Description

Comment & Rating (4)

License

Related Models

8BitDo Lite/Lite 2/Lite SE Controller Adapter

Print Profile(1)

Description

Comment & Rating (4)

License

Related Models