Mini Sheet Metal Brake
Print Profile(1)
Description
This is a Miniature Sheet Metal Brake, used for bending precise angles on thin gauge sheet metal/plastics. 100% 3d printed, NO additional hardware or accessories required.
Overall dimensions after assembly are roughly 13.5 in. X 6.5 in. X 2 in.
Clamp bolts print in place and should spin freely with little vertical/horizontal movement.
Hinge pins should fit snugly and will lock into place (may require lightly tapping with a hammer to fully seat).
Infill is set to 100% (solid) for strength and rigidity, it is recommended to keep this setting.
Assembly is pretty straightforward. refer to pictures for broken down view.
I printed mine out of BL's PLA Basic. Not yet sure of its maximum capabilities. Bends 1/32"(.8mm) aluminum plate with ease (shown in pictures). If strength is a concern, consider using a stronger filament.
Again, this tool was designed, and intended for, thin gauge sheet metal.
****CAUTION****
When clamping materials, it is possible to overtighten, which could result in the clamp/bolts bending or breaking.
The clamp is only intended to keep material secure during bending operation. Be careful of overtightening, especially with thicker material being clamped/bent.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)