Search models, users, collections, and posts
V400 LED Diffuser
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
40 min
1 plate
Open in Bambu Studio
Boost
5
11
2
0
39
9
Released
Description
Diffuser is quite useful for preventing overexposure on the webcam (if installed). Making it a lot easier to see the print clearly.
Slightly difficult to install due to the snug fit, but once it's clipped into place, no glue or screws are required.
1 layer wall, 0 infill gave me the best result for brightness and diffusion. Print in white for best transparency and diffusion. Colored filaments work, but will drastically cut down the brightness. Haven't tried clear filament.
Model is made slightly short on both ends on pupose, so that it clear the rods, giving it full range of motion.
Orca Slicer Project file for V400 included
Great print to for any leftover filaments, as it doesn't require much to print.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (2)