Rotating Filament Swatch Display -both sides+Logo
Print Profile(5)
Description
Rotating Filament Swatch Display + Bambu Lab Logo
- spinning in both directions
!! It is recommended to clean the print bed before printing !! - For a clean first layer !!
Layer height : 0,08+0,2, line width : 0,4
Walls 3; top 0,8mm ; bottom 0,6mm
infill 15% ; print time ~ 5h 43min
!!!! I have revised my profiles! Both parts are X&Y scaled to 102.15% !!
Not all filament swatches are the same !
To run smoothly, sometimes they need to be deburred a bit !
You can also sand the ramp in the ground and lubricate it with a little oil !
!! For a better stand you can added some rubber grips to the bottom !!
“ LID ” for Rotating Filament Swatch Display :
https://makerworld.com/de/models/1707091-lid-for-bambu-filaments-rotating-display#profileId-1810998
Another Case for filament swatches :https://makerworld.com/en/models/512695#profileId-428796
Bambu Lab PLA Matt Charcoal + Bambu Lab PLA Basic Bambu Green
MakerWorld : https://makerworld.com/en/@sweb3791
My Models : https://www.printables.com/de/@CB_384764/models
This remix is based on
License
Comment & Rating (769)