Search models, users, collections, and posts
Krobus figure from stardew valley
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Open in Bambu Studio
Boost
31
104
12
6
108
74
Released
Description
Your little desk buddy for all the Stardew Valley sessions.
Yes, he can stand on his own (I know it does not look like it in the pic) It took quite a bit of figuring out. He has more infill on the bottom and the feet can look a little weird from some angles but I swear it looks ok from the front.
I don't recommend turning off just necessary support because it can be hard to remove supports from his small fragile feet and deep mouth.
Also, I don't recommend making him smaller than 70mm. Removing the support from his head swirl can be hard. You can try it if you have a really steady hand or PVA filament for support.
Happy printing :D
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (12)