Working Thead Holder v2.0
Print Profile(2)
Description
You should probably go check out the v3.0 release of this thing!
I made some updates and enhancements to my original spool holder I built for my wife. The original was just a block base. This new version uses dovetails to interlock the two pieces. I also increased the strength of the posts by changing the joint at the bottom to be rounded. Not like spools of thread place a lot of stress on the thing, but best practices are best practices for a reason, right? Of course, this also means 2 distinct models - left & right.
A Left & Right pair of these fit together really nicely in the model 11012519 tray from The Container Store, as shown in the pictures. I've also got some little silicone non-slip things on the bottom of the base to keep it from sliding around in the tray.
Boost Me (for free)
Thank you all for your kindness, Likes, Downloads, Makes, and Boosts. Your likes, makes, boosts, and downloads help fund my supply of filaments, parts that gets used in prints, as well as consumables and various spare parts. Thank you so much for your support!
Membership
If you'd care to offer some additional support, please consider becoming a member at the Tip Jar (or higher) level. Thank you! If you’re interested in a commercial license to sell my prints, please have a look at the commercial plan offered here.
This remix is based on
License
Comment & Rating (10)