A1 Mini clip for wiper - only 0,17 g - Free 3D Print Model

Search models, users, collections, and posts

Franz

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.12mm layer, 2 walls, 15% infill

Designer

11 min

1 plate

4.5(58)

Open in Bambu Studio

Boost

146

382

615

216

Released

Description

I have constructed a clip that can be easily slid over the original one, reducing the gap between the hotend and the wiper. This way, excess plastic will be wiped clean in 9 out of 10 cases. Feel free and try.

Comment & Rating (67)

@Bw3dEmporium

Print Profile

0.12mm layer, 2 walls, 15% infill

calling that one a bust GG guys

@D4MuTz

I had that too

Show original

@fedskie

me too

@tims3D

Print Profile

0.12mm layer, 2 walls, 15% infill

Works also for the A1

(Edited)

@movrack

Adaptation possible for the A1 model? This one is too short

Show original

@Florin_89

Print Profile

0.12mm layer, 2 walls, 15% infill

it's ok

@user_2265952633

Print Profile

0.12mm layer, 2 walls, 15% infill

Works Great! Thanks

@1boch1

Print Profile

0.12mm layer, 2 walls, 15% infill

@user_249145940

Print Profile

0.12mm layer, 2 walls, 15% infill

Printed well and it's doing what it's designed to do. Thank you for sharing.

The profile uploader has replied

@franz_roll

no Problem;)

@ZeruThe_Wolf

print this in PETG not pla. I believe other users may have used pla which will stick to the discarded filament.

@chesborga

I have a feeling that the hotend will melt this if it c ok mes into contact right after extruding

@bullber

If you print it in pla and then use other materials that require higher temperatures, it might not be immediate, but it will surely melt it little by little, leaving a mark with each pass and losing effectiveness with each use I thought about printing it in tpu but in the end I opted for another model A brush placed at the exit of the purge bin

Show original

@movrack

Print Profile

0.12mm layer, 2 walls, 15% infill

Do not fit a1 but my fault I didn't read well the description. Also using pla was wrong choice cause it melt with the hot coming poo

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.