Target for rubberband guns, disc shooter etc

Improve your shooting skills with these nice targets with swivel mechanism.

They work well with rubber band guns and disc shooters.

I have not tested them with Nerf guns, soft air pistols etc.

Assembly:

• Mount the Arm on the left holder wit axis. The arm must rotate completely free.

  

• Mount the right Arm holder

  

• Press these 3 parts on the ground plate

  

• Attach the disc. I recommend a drop of glue for it.

  

Print Settings:

If you don’t use the Print Profiles:

See the 3D Preview for correct part alignment on the print plate.

You need no supports, no brim.

Standard settings with 0,2mm layer height.

For dual color disc: Add a filament change at layer 5 (when using 0,2mm layer height).

The disc diameter is Ø50mm. Scaling should be possible in a little range. Try at first the arm and the holder part with axis. If the joint works freely, the rest should be no problem to assemble.

I also tried a version with three targets on one large base plate, but I had too many problems with more than one target falling over. So if you want more than one target on one plate, I would recommend gluing them to a wooden board. It should work much better because of the weight.