Search models, users, collections, and posts
IBM Model 95 CD Bezel - Improved Latch
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
1
3
0
2
3
0
Released
Description
This is a long-awaited improvement to my CD bezel for the IBM PS/2 Model 85/95 computers. This should also fit models 35/40/56/57/76/77, but I have not yet tested.
Installation Notes
When installing, insert the tabs into the slots on the right side (when looking at the case), then slide the top left "+" into place while slightly bending the lower frame and sliding the extra notch on the lower tab behind the metal. The combination of the tight fitting “+” and the lower notch will hold the bezel fairly firmly in place.
When removing, make sure to lift the top left corner so that the “+” is removed first, then you can slide the lower tab out of position. If you do not remove the “+” straight out, it will easily get sheared off.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)