Saturn 4 & Ultra -Bed handle and Tilt Dripper V2

I have redesigned this model to be printed in PETG with a .6 nozzle for better strength.

I have chosen to print this as a single piece so there are supports required, depending on your filament you may still get a bit of sagging on the print, I printed in bambu petg and the part is very strong.

Here are the changes i have made:

• re-alignment of the screw holes
• increased wall spacing for a better fit
• added thicker walls to the hook connector for better strength
• added a lock for the hook connector

You will also need 25mm M4 self tapping screws, you will have to cut the tip of the screw so that only 16mm of the screw comes through the hole, pair of cheap screw cutters will do the job

Buy Me A Coffee

I am not responsible for any damage this mod may do to your printer, you print and use this at your own risk.