Search models, users, collections, and posts
SUNLU S4 Filament Plug with Push Pin Release
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 100% infill
Designer
54 min
1 plate
Open in Bambu Studio
Boost
161
542
102
24
534
370
Released
Description
I recently purchased a SUNLU S4 Filament Dryer. I began looking for any S4 mods that could improve the S4. I noticed the Filament Plugs posted by SUNLU for the S4. I printed them and after installing one, I realized they would be a pain to remove. As a result, I put together this S4 Filament plug with Built-in Pin Release. Being the parts are small and could be broken easily and they would be used in a high temp filament dryer, I decided to print them with PolyMaker PolyLite ASA and 100% infill. Assembly, Installation, and removal of the Filament Plugs are self explanatory by looking at the parts and the assembled Filament Plugs In the pictures. Thank you for any comments and/or suggestions. Have a blessed day and stay safe!
Regards,
CC
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (102)