toddkrein

0.16mm layer, 2 walls, 15% infill

Very nice and solves a safety problem I wanted to address.  Printed these in Bambu PLA orange for high visibility.

Robert Sink

Nice simple cap.  I used this in a pinch but it was a bit on the tight side.  Thankfully, hammering them on with a  rubber mallet did not make them split.  Next time I will scale these 102%

ZeroPrint

Braeside Lego Fan

Fit a bit loose so had to scale down to 98% but printed without any problems otherwise.

Eclectic

timothy.h.sample

user_3496732832

David Youd

rfc6592

Benbjamin

cover

PXL_20240620_041610950[1]_88c67cfd-f1b4-4762-b458-17f5319fc86a.jpg

PXL_20240620_042932847[1]_5a6723bb-187d-4674-9ecc-b82bdafc6d08.jpg

plate_1.png

RGMakes

IMG_7332.jpeg

IMG_7330.jpeg

2024-06-29_2900341f95b3d

<ul><li>Reduced the size of the caps for a more snug fit on ½" EMT with an 18mm exterior diameter (common in the US)</li><li>Print four caps at once</li><li>.16 mm layers with 0.4 nozzle and smooth plate</li></ul>

<p>I printed these 19 mm conduit end caps in PETG. The walls are just flexible enough to grip the ends of the pipe firmly. They really clean up the look on the ends of my filament shelves.</p>

1/2 inch EMT conduit end cap 

ASIA

Print Profile(1)

Description

Comment & Rating (16)

License

Related Models