Search models, users, collections, and posts
Super Twisty Oreo Spinner
Remixed by
IP Report
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
54 min
2 plates
updated oreo gear and connector
12 min
1 plate
1 plate, by object, updated gear, 0.2mm, 5 walls, 75% infill
49 min
1 plate
(Recommended) Improved axle and spring
4.1 h
5 plates
Open in Bambu Studio
Boost
2124
5231
587
94
9.9 k
7.7 k
Released
Description
Description
Twist this cookie the same way that you would twist an actual Oreo! The clicky result is super satisfying.
This model is based on the original Super Clicky Oreo Spinner by JamesThePrinter. I made two significant changes:
First I altered the dimensions of the cream filling part to more realistically represent an actual Oreo cookie.
I also re-designed the center gear to allow for the twisting motion.
Assembly
- Start with one wafer upside-down. Then glue the filling ring to the wafer. The ridge on top of the ring should be facing up.
- Assemble the two halves of the center gear. The top of the gear has a small indentation where the two halves connected. If you twist the two halves, the teeth of the gear should move with the top surface.
- Glue the gear to the upside-down wafer in this orientation.
- Glue the remaining wafer to the top surface of the gear.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (587)