Search models, users, collections, and posts
wrist res ntop
Remixed by
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
32
66
2
0
115
29
Released
Description
Content has been automatically translated.
Because soft rubber material is not breathable, too much hand sweat will affect the user experience. I saw the hollowed-out handrests online, but they are expensive.
I used ntop to generate a mesh to replace the original structure. It has good breathability, but it is a bit hard. I will continue to optimize it later.
The mesh is too dense. It is recommended to dry the filament thoroughly and lower the printing speed. Otherwise, you will get stringing like me.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)