GPS GY-GPS6MV2 MODULE CASE NEO-6M
Print Profile(1)
Description
The module allows you to add GPS support in a microcontroller system (eg Arduino ), and the built-in NEO-6M system gives great possibilities and ensures high precision of measurement. The module has a built-in cell supporting RTC clock settings.
The GY-GPS6MV1 module is a board containing the U-blox NEO-6M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART signal outputs.
Properties
- GPS system: U-blox NEO-6M
- Transmission type: UART (lines Rx, Tx)
- Received band: L1 (1575.42MHz)
- Positioning efficiency: 3 m on average
- Drift: <0.02 m / s
- Reference system: WGS-84
- Maximum height: 18.000 m
- Maximum speed: 515 m / s
- Acceleration: <4g
- Tracking sensitivity: -161 dBm
- Sensitivity of acquisition: -148 dBm
- Average time of "cold start": 38 seconds
- The average "warm start" time is 35 s
- Hot start time: 1 sec
- Average recovery time: 0.1s
- Working temperature range: -40 ° C to + 80 ° C
- Power supply range: from +3.5 V to +5.5 V
- Bus voltage UART: 3.3 V
- The soldering points allow the antenna to be mounted on the PCB
- Built-in RTC backup battery
- Built-in u.FL connector for antenna
- Module dimensions (without antenna): 36 x 26 x 4 mm
- Dimensions of the antenna: 25 x 25 x 8 mm
Give me a like and follow my page.
If you need help or you want to be printed this parts or customized in different way, just send me a message here.
Thank you to support me and happy printing.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)