Table stand for MCO Home - CO2 Sensor for Z-Wave
Print Profile(0)
Description
Summary
I'd appreciate if you post some makes here! ;-)
I bought the MCO Home - CO2 Sensor for measuring the air-quality in our bedroom during the night.
Unfortunately it is intended to be mounted to the wall, which I did not want for two reasons:
- Ugly holes in the wall and where to route the cable?
- I may use it in any other room for a little monitoring, which is impossible when attached to the wall.
So I designed this stand, which prints in ~4-5h does a decent job in holding it on any table or shelf.
Please see the print settings - the STL orientation is not correct!
Print Settings
Printer Brand:
Anycubic
Printer:
All-metal Mega
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0,2
Infill:
35%
Filament:
Verbatim PLA
Notes:
Print sideways (lying on one side), not as saved in the STL.
If you print it sideways, the fibre-orientation is a lot better which is way more stable.
You may use two of the typical computer-case hex screws which fitted my pre-printed holes perfectly.
License
Comment & Rating (0)