9×9 - Flip the Go Board (Reversible Go/Gomoku/Draughts)

Portable 9x9 Gomoku/Go

The pieces have three sides, and you can change the state of the piece by flipping it.

This is a set of flip Go. Each piece has three sides, and the state of the piece can be changed by flipping it.

One problem I encountered during testing was that the black and white sides are larger in volume, so they are also heavier.

When switching to the black and white sides, the uneven weight on both sides of the axis can easily cause tilting.

Therefore, it is particularly important to maintain the balance of weight on both sides of the middle axis when the pieces are on any side.

My solution is to increase the weight of the side without pieces in the slicing settings and reduce the number of walls and infill on the black and white sides.

After multiple tests, a relatively balanced effect has been achieved. You can download the configuration file and print it directly.

It is strongly recommended that you do not export my model to STL and then slice it yourself to print, otherwise you may also encounter the problem of uneven weight of the pieces, unless you are patient enough to do several tests.

A 13-way version will be uploaded later. If you have a version you like, you can leave a message.

Due to the large number of moving structures, it is recommended to use good consumables.

Printing Tips: As some parts of the model have a small contact surface with the heated bed, they may detach from the heated bed during the printing process. To increase the printing success rate, please clean the printing plate with dish soap and spray glue before printing. Using a low - temperature warming printing plate can significantly enhance the printing success rate.

Feel free to leave a comment if you have any suggestions or questions about the model. When problems occur, please tell apart whether the issue is caused by the model itself, the printer, the filament, or improper operation and installation on your own part. I will block users who blindly attribute printing failures to the model and leave a one-star rating simply because they are unable to troubleshoot and fix problems by themselves. Such behavior greatly undermines the efforts of open-source creators.

有任何关于模型的建议或疑问，欢迎评论留言。出现问题时，请先区分原因：是模型本身、打印设备、耗材，还是个人操作与安装不当造成的。对于自身没有排查和解决问题的能力，却一味将打印失败归咎于模型并给出一星差评的用户，我将进行拉黑处理。这类行为会严重辜负开源创作者的心血与付出。