Working Flashforge Adventurer 3 Duct / Clip

I'm designing my models in Autodesk Fusion, as a hobby, but looking to expand my portfolio. If you like my designs please consider following me by clicking the green “Follow” button next to my avatar.

Before printing as always you should make sure you have made a recent “Flow Dynamics Calibration” in Bambu Studio for the material your using. And have your plate cleaned the proper way.

Model Info:
 

Ive been trying lots of different alternatives to the original air-duct to the Flashforge Adventurer 3, but they have all had some fault.

Either the nozzle was not changeable or the design did not have all the design features that made it mount properly without loosen up after awhile and make the nozzle drop out of the socket while printing.

So this is a remix of measurement taken from the original part and also these models:

https://www.thingiverse.com/thing:3126616
https://www.thingiverse.com/thing:5379497

Should be printed in PETG or other heat resistant material.

Also included is my version of the clip holding the printbed.

Support Me:

If you print my designs, please take the time to rate them.
If you like the result please support me by just a simple, like, comment or follow…
Feeling extra generous ?… i wouldn't mind a Boost, or perhaps buy something in my Ko-fi shop:-)