Search models, users, collections, and posts
Class 15 Bobbin Clip
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
57 min
2 plates
Open in Bambu Studio
Boost
16
54
19
2
152
120
Released
Description
This bobbin clip is based on a model for a Singer bobbin clip shared by @DebClutter. The Singer clip was the same diameter as a class 15 bobbin, but was 3.7mm shorter. A Class 15 bobbin is 1"/21mm diameter x .4"/11mm height. I extruded the original model an additional 3.7mm and the new model fits my wife's bobbins perfectly! I used a 3mm brim and no glue to print these on a Bambu Textured PEI plate with Bambu PLA. The brim peeled off the prints without any issues. I retained the licensing of the original designer, with the addition of Share Alike.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (19)