Search models, users, collections, and posts
Gridfinity with pin USB A storage
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 13% infill
Designer
27 min
1 plate
Open in Bambu Studio
Boost
79
290
83
6
567
383
Released
Bill of Materials
Bambu Filaments
Select all
Description
For this remix I sliced off the bottom of a gridfinity USB storage design and added the bottom of the gridfinity with pin design instead to make it compatible. Note that the USB sticks are not a tight fit but have a little slack so they go in easily.
The holder is still 100% compatible with standard gridfinity bases but the gridfinity with pin allows it to click into place. No magnets required.
The base is here:
https://makerworld.com/en/models/440624#profileId-346300
See here for a collection of gridifinity with pin designs put together by One Maker Show the designer of this system:
https://makerworld.com/en/@OneMakerShow/collections/1143270
Print Instructions
- Filament : PLA works really well I've not found a need for stronger, but you could use anything
- Infill: As per profile works great but you can easily reduce it by a few percent as nothing is under stress with this
- Drying: Always well worth drying your filament whatever it is, you will get better results with dry filament!
Boost Me (for free)
Useful for you? Feel free to give it a boost :)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (83)