Search models, users, collections, and posts
Gringotts Piggy Bank with Dragon Lid
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 20% infill
Designer
13.6 h
3 plates
0.2mm layer, 3 walls, 20% infill
19.6 h
3 plates
Open in Bambu Studio
Boost
126
289
11
16
210
113
Released
Description
This is a remix of two models. I wanted the Gringotts bank as a removable top piggy bank and a dragon on top. There is a normal lid included as well. The dragon can print completely support free and is colored in the 3mf. The bank can print mostly support free if you slow down overhangs and bridges. I used tree supports at a 4 degree angle to only have the front overhangs supported. It can print completely support free if you clean up the over hangs in the front.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (11)