Dummy 13 BETA Light Armor

UPDATE: https://makerworld.com/en/models/822139#profileId-765368

 

Right off the bat, I'm going to say it's important that your printer is properly calibrated and dialed in for this print if you're doing it at standard scale; retraction being a major factor. I'd personally recommend 150% and over for this, but I was able to get two standard scales to print well enough that I'd say it's absolutely possible. Included are individual parts and all the parts plated with mouse ears. I strongly recommend the latter. If printing at standard scale, be aware that parts will be very brittle and delicate. Might require cleanup with an exacto to correct dimensions on parts that are basically just dots of filament going up.