Search models, users, collections, and posts
Ender 3/Pro, Fan Duct Voron style
IP Report
Print Profile(3)
ASA 0.16mm layer, 3 walls, 25% infill
Designer
3.5 h
1 plate
ABS 0.16mm layer, 3 walls, 25% infill
Designer
3.4 h
1 plate
PEGT 0.16mm layer, 3 walls, 25% infill
Designer
3.5 h
1 plate
Open in Bambu Studio
Boost
57
65
10
2
133
22
Released
Description
v1 of my Fan duct for a good old ender 3. Please print in some higher temp materials such as PEGT ASA or ABS.
parts needed
5015 fan
6x m3 6-12mm screws
that's it.
install so easy it's dumb. remove old, slide the mounting plate down around the hotend, screw the originals screws in, place fans on the mounts, and ensure it all fits at the wires and is run nicely. then lastly screw the cover on and you're done. Happy printing!
DON'T USE SUPPORT!/only use touching the built plate or you will fill the part cooling air run thingys with supports that will block airflow.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (10)