Search models, users, collections, and posts
5pcs Plate Holder Reduced
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.7 h
1 plate
Open in Bambu Studio
Boost
6
15
3
0
28
8
Released
Description
The original Designers model is a great design. The only change made was I reduced the height of the channels. This reduces the amount of filament used by 100 grams and reduces print time by over 1 hour.
Additionally, the holes were enlarged to accept a threaded heat insert:
https://www.amazon.com/dp/B08T7M2H4S/?coliid=I2MMZ656K082D3&colid=3GPF1UHF51V27&psc=1&ref_=list_c_wl_lv_ov_lig_dp_it
If the designer makes this change, I will remove my design.
You will need the front and rear ends available from the designer:
https://makerworld.com/en/models/19745#profileId-22960
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)