Search models, users, collections, and posts
Boot Jack - Device for Removing Shoes
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
6.2 h
1 plate
Open in Bambu Studio
Boost
54
98
5
4
98
40
Released
Description
Summary
back hurt? cant bend over? try the new shoe aid remover. really if you dont like stepping on the back of your shoe to get it off and dont like untying them this might be the solution for you.
The dimensions of the model are too large to print at one time. So I divided it into two parts. These parts need to be glued together and then the thing will be very strong.
On the lower platforms that are adjacent to the floor, it is better to glue soft rubber on glue or double-sided tape.
Filling 10% is enough that you can step on your foot, and at the same time not spend extra material.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (5)