key ring phone holder

Here is my latest creation: a phone holder that can be attached to your keychain!

I've made two versions: one with a TPU layer and another simpler version.

For the simplest version, you only need two files to print:

• NO TPU phone holder P1
• NO TPU phone holder P2

For the version with a TPU exterior, you will need:

• TPU P1
• TPU P2
• wth TPU phone holder P1
• wth TPU phone holder P2

Assembly

To assemble, in both cases, you need to remove the supports first. Then, you may need to apply some force to fit the two ends into the slots. If necessary, apply force in the opposite direction to retract the two tabs back to their original positions in the holes

("I'm not sure if it's clear, but to insert them, don't hesitate to apply force on them.)

For the TPU, you take strong glue and place it on the designated areas. That's it, and now you can carry it everywhere and at all times with you.

Here you go, now you have a compact and easy-to-use phone for travel.

Good impression :)