Search models, users, collections, and posts
AR-15 Accu-wedge (slack remover)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
871
2765
115
50
2.4 k
1.7 k
Released
Description
Membership
Looking for Commercial Licensing or just want to support me? Looking into these options. :)
Join
Boost Me (for free)
If you enjoy, consider boosting! :)
Have a good day! :)
Fills in the slop/wiggle on a standard AR-15.
No support is needed, print in place.
Depending on the application you might want to scale the print up or down 1-3%
The fit should be VERY snug.
The more temperature-resistant the filament, the better.
License
If you want to use this model commercially, please join my membership.
Join Now
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (115)