Revised Gasket to hide LEDs (so they don't blind you) Remixed by nkamenar.it

Remixed by

nkamenar.it

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

4.3 h

1 plate

5.0(61)

Boost

168

419

1.1 k

471

Released

Description

I modified the gasket to have wings that make it so the LEDs can shine into the printer, but they are blocked from direct view when you are looking into the printer. Makes it much more pleasant so the bright LED strips don't blind you every time you check on a print.

Comment & Rating (93)

@Waters

Print Profile

0.2mm layer, 2 walls, 15% infill

prints great, helps a ton with blocking the LED strip from shining directly into my eyes

@jawknee21

How does the back middle one not shine in your eyes? How are your wires routed to go around both sides?

@Waters

Replying to @jawknee21 :

the back does shine in my eyes when I go below the lip of the BLV, but I don't have to do that very often(almost always it's just for maintenance, not regular operation) so it's not nearly as big of an issue as the sides were. I have a zip tie for my spare wire that I have by the USB power port, mostly because there is a ton of extra cable with the controller box. I cut the strip to size using the marked cut areas so I only have the power in excess cables to deal with

(Edited)

@drewber09

Print Profile

0.2mm layer, 2 walls, 15% infill

Great print. do wish it hid the back side as well

@k.kiutra

I made a Remix that also covers the back if you are interested. https://makerworld.com/en/models/473980#profileId-384195

@ipdoyou

Print Profile

0.2mm layer, 2 walls, 15% infill

worked perfectly!!! no more being blinded looking in from the top

@MinerJ

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed great in Overture TPU, helps greatly with directing light

@davidfontneau

Print Profile

0.2mm layer, 2 walls, 15% infill

Fits perfectly! First time printing with TPU, had some stringing and weird little artifacts around the pegs that slot into the riser but all was easy to clean up.

@wojtek.jaromin

Print Profile

0.2mm layer, 2 walls, 15% infill

@shamanz123

What length of leds fit the riser? I’m currently printing it out but can’t find the length mentioned anywhere.

The designer has replied

@nkamenar.it

Not sure what the exact length is, but I just bought this LED roll. You can cut it every 8mm so you just cut it to your preferred length: https://www.amazon.com/dp/B0B7CXX2G6?ref=ppx_yo2ov_dt_b_product_details&th=1

@shamanz123

Thank you, I’ll check it out

@jawknee21

how long did you end up using?

@LongBeachRaider

Great Profile

The designer has replied

@nkamenar.it

Thanks!

@UhhItsAnt

Are you able to add a lip to the rear and front as well?

@k.kiutra

I did a remix if you are interested for the back. https://makerworld.com/en/models/473980#profileId-384195

@noeneel

How do you actually install the LEDs?

@Mason340

Commenting as i am interested too. Can you chain them into the original LED power cable or is it best to use a seperate power source altogether? I have just finished my print, came out fantastic