Arduino Case Mega 2560

Hey,
I made this Case for the Arduino Mega 2560, it fits all common modells of the Mega 2560. Your Arduino can optionally be screwed to the case for optimal grip, but it also holds without screws (as you see in the pictures).


Disclaimer / Terms of Use

• Use at Your Own Risk: This design is provided "as is" for hobbyist purposes only. I am not a professional engineer and shall not be held liable for any damages (property damage or personal injury) resulting from the use or failure of this model.
• Material Selection & Preparation: You are responsible for choosing the correct filament (e.g., heat-resistant or flame-retardant) for your specific application. Ensure that the filament is completely dry before printing. For maximum structural integrity and mechanical strength, it is necessary to use a freshly unpacked, new spool of filament.
• Electronics Warning: When used in combination with electronics, ensure proper insulation and adequate ventilation. Do not use this model with electrical voltage unless you are a certified professional.
• No Warranty: I cannot guarantee the mechanical strength or dimensional accuracy of the print, as 3D printing results vary significantly depending on the printer, calibration, and individual settings.