Raspberry Pi 3 case for 2020 / 2040 extrusion

Summary

I wanted a slim Raspberry Pi case to attach to my Folger Tech FT-5 and fit within the rear control box. Mount with short 5mm bolts and t-nuts.

Note:
Spacing from the center of the bolt holes to the start of the pi case itself is 20mm, so there should be roughly a 10mm gap between the case and the 2020 extrusion.

Print Settings

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

Whatever you want

Notes:

Print with flat sides down on the build plate, easy enough.