Tool head cover maintenance holder/hanger for Bambu Lab X1 P1 by lukasglowinski

lukasglowinski

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 6 walls, 25% infill

Designer

20 min

1 plate

4.9(37)

Open in Bambu Studio

Boost

129

285

196

Released

Description

Simple tool for holding the tool head cover during the changing of nozzles or any other maintenance action.

Printed in PET-G (extra flex). It clicks on the carbon rods and the cover fits in the groove above.

Most likely it will also work with P1 models but I can't check it for sure because i don't have one :)

Edit: As confirmed by one of the owners of P1 it works fine as well.

Comment & Rating (43)

@arellano4710

Print Profile

⭐𝐅𝐚𝐬𝐭 ‣ [PLA] 0.20mm

came out really good 👍

The designer has replied

@AneoPsy

Thanks for reviewing, I appreciate the feedback.

(Edited)

@craig.wagner

Print Profile

0.2mm layer, 6 walls, 25% infill

Love it! I've been looking for a solution other than leaving the cover dangling or precariously balancing it on the rods. All the other solutions I've found blocked the cutter. This one allows the cutter to fall away if you want to remove the extruder. Thanks for the design. Printed in BBL PETG-CF (brick red).

The designer has replied

@lukasglowinski

Thanks a lot for a good word :) Blocking of the cutter with other holders was the main reason I've made this one.

@warlogh

Print Profile

0.2mm layer, 6 walls, 25% infill

firstly I was quite excited about this model, but had some concerns about fitting to the rods. and my suspicious were right. Hanger fits on carbon rods very tight. Almost broke them trying to get hanger off. as you can see on photo hanger deformed during detach. Idea is good, actually exactly what I was thinking. but going easy way didn't work for me so I had to go and make my own one.