Search models, users, collections, and posts
X-Pander3 Case (Commodore 64)
IP Report
Print Profile(1)
0.2mm layer, 7 walls, 15% infill
Designer
2.5 h
1 plate
Open in Bambu Studio
Boost
5
9
0
0
14
6
Released
Description
Bottom can be printed without supports. Top was done with supports on the side and cartridge portion.
Requires 2 M5x16 screws - you can also add two shorter M5's to the rear two holes to help lock the PCB in place, but they can't extend past the PCB or they'll block cartridge insertion.
The X-PANDER3 is created/sold by Retro Innovations: https://store.go4retro.com/x-pander-3-slot-cartridge-port-expander/
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)