A1 Mini Printer - Update: Print it in Parts

This is the Updated version of: https://makerworld.com/en/models/2965078-playdoh-a1-mini-it-actually-prints#profileId-3324485

Fully 3D Printed A1 Mini - And it actually prints!!

Now even young kids can 3d print, with this playdoh compatible A1 Mini Bambu Lab printer. And, the best part, it's fully 3d printed!! Only 3 simple piece are necessary, and there are two different printer versions available. Simply roll a very small amount of Playdoh (even the smallest tub will have enough!) until it becomes like a ‘snake’. Load that into the hole on the top of the nozzle piece, and push the T-shaped piece down. There are 3 different places to load the nozzle, so you can print any design you can imagine! If you print the one way version, you can slide the nozzle while you ‘print’. 

Important: When you are ‘printing’ the playdoh, hold and push the Nozzle, not the printer. 

I used tree supports for the printer, and they came off with no trouble. The other parts shouldn't need supports. Before you begin, it may be a good idea, (based on the strength of your filament) to reinforce the sides of the nozzle tip with hot glue. t would mean a lot to me if you would leave a like, and comment with photos of your printed model. Thank You!! 😃👍

If you have suggestions for which Bambu Lab printer I should make next, leave a comment!

Specific Instructions for this Version:

The parts assemble easily, but super or hot glue may be needed. The Extruder and push piece are the same as the original model.

Have Fun!!