BC-250 case V4.2 - for HPserverPSU, DUAL 12cm FANS

Since many people asked about a dual-fan case for BC250 (for stronger cooling, especially for unlocked 40CU ones), I created this version:
 

This is a modification of my previous design:
https://makerworld.com/pl/models/2481620-bc-250-case-v4-for-flexatx-and-hpserver-psu

Only the case body (have place for two 12cm fans) and the fan cover have been changed (it's longer and reinforced). 

There are also minor cosmetic changes (like a slightly tighter space for the USB hub, minor rounding for better printing, etc.) – but these don't change anything important. All other case components (front and rear panels, feets, 5015fans dummy/covers) fit and are the same, unchanged.


since the new fan shroud is relatively large 279.42mm - I am providing it as 2 objects, it can be printed as one whole (if you have a large printer like H2S/H2D/A2L etc) or as two objects, and glued on the middle reinforcement.