Search models, users, collections, and posts
Disc Shooter Mk4
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15-40% infill (infill and supports preset per plate)
5.8 h
5 plates
Open in Bambu Studio
Boost
285
519
66
4
946
886
Released
Description
This model is the property of ma-unique. All I did was to set up suggested settings for each plate into a 3mf to save time.
The assembly video is linked to from his Printables page printables.com/model/281019-disc-shooter-mk4.
Plate 3 is suggested to use a brim I tested it without and it worked just fine for me so that is how I included it. The disc plate is suggested at 20% infill I left mine at the slicer default of 15% which saves a whole 0.41g of filament and 30 seconds. The disks are incredibly easy to lose so bright colors that don't blend in with your floor would be recommended.
The user shared this model, but is not the original creator of it.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (66)