Search models, users, collections, and posts
Heltec T096 18650 Case
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
3
10
10
2
5
6
Released
Bill of Materials
List other parts
- battery terminal clips x 1: (optional)
- LoRa Antenna x 1:
- M2*6 hex screws x 4:
- 18650 Battery x 1:
- Heltec T096 x 1:
Description
This is my 3rd iteration on coming up with the most compact form I can make a Heltec T096 and 18650 fit.
Features
- Lid clip to prevent bowing in the middle
- Taller shape to fit the hand better.
- Fits 18650 cell.
- lanyard loop at the top.
- I think the top might be possible to add a GNSS antenna but it's not required and I haven't tested it. should fit a 15x15x6 mm antenna.
- Updated to add spring clip slots
Print Settings
- Layer Height: First layer 0.2 and 0.16 after
- Nozzle: 0.4
- Material: PLA
- Infill: 15%
- Walls: 2
- Supports: Not needed
Assembly
- Put the battery in
- Install SMA connector
- Install T096 first by slotting the USB-C connector in first. (might need to sand the overhang)
- Make sure the wires and antenna don't get in the way of the rails on the sides when pushing the T096 down.
- Snap cover on and fasten with 4 M2*6 screws. (mine are Vigrue brand 1080 piece set)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)